This is the outline of today's Packet Tracer
Place and connect the router.
• Place the router in the topology.
• Add a module.
• Connect the router to the neighboring devices.
• Perform the basic configuration.
• Change the router names.
• Configure interfaces.
• Complete the configuration.
• Add passwords.
• Verify the configuration.
This was my first time making a fully stable network from scrap. All i am given in this situation was routers and switches and end devices. I had to know what cables i needed to connect to different ports, i needed to give them ip addresses, i needed to configure the router, and i need to put names for each device. First thing i did in this Packet Tracer was i connected each device together and added a router and enabling it. Then i managed my configuration by setting up new passwords and testing out my network statistics. Then i tested the network to see if it works by using Check Results and simulation; the Test was success.
No comments:
Post a Comment