PT 3.2.5.2 Packet Tracer: Convergence

My Objectives for this Packet Tracer is to...
______________________________________________________________________________________
-View the routing table on a converged network
-Add new LAN to topology
-View debugging output
-Watch the network convergent process
-Putting a new Network in an existing one

What was learned via RIP updates for Router 2? What i learned was that both router 2 and 3 were on the same subnets via 192.168.1.2 Serial 0/0/0

What network was learned via RIP updates for Router3? The network that was learned through Router2 and 3 was that they are in the same LAN network.

Next i add a switch (followed by a host) to router3 so i can have an extra subnet with another host. After that i use ip configuration to enter the new network information for PC2 (Which is the new host for the switch). What was new was i had to use router rip to add the new protocol into the connected network. Next i view the debugging output for the network in all of the networks. Finally, i turn off the debugging and i ping from PC2 to PC0 to see if my new whole network works.